ADTRAN 1000R Series - Manual (Page 856)

Command Reference Guide Frame Relay Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 856
frame-relay lmi-type [ansi | auto | cisco | none | q933a]
Use the frame-relay lmi-type command to define the Frame Relay signaling (LMI) type. Use the no form
of the command to return to the default value.
Syntax Description
ansi Specifies Annex D signaling method.
auto Automatically determines signaling type by messages received on the frame
circuit.
cisco Specifies Group of 4 signaling method.
none Turns off signaling on the endpoint. This is used for dial-backup connections to
ADTRAN IQ and Express series products.
q933a Specifies Annex A signaling method.
Default Values
By default, the Frame Relay signaling type is set to ansi.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Release 2.1 Added signaling type none to provide support for dial-backup to ADTRAN IQ and
Express series products.
.
Usage Examples
The following example sets the signaling method for the endpoint to cisco:
(config)#interface frame-relay 1
(config-fr 1)#frame-relay lmi-type cisco