Sntp retry-timeout <time – ADTRAN 1000R Series User Manual
Page 513
Advertising
Command Reference Guide
Global Configuration Mode Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
513
sntp retry-timeout <time>
Use the sntp retry-timeout command to set the amount of time to wait for a response before allowing a
new request.
Syntax Description
<time>
Specifies time (in seconds) to wait for a response before retrying. The range is
from 3 to 4,294,967,294.
Default Values
By default, the retry timeout is set to 5 seconds.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R and Total Access 900 Series units.
Command History
Release 8.1
Command was introduced.
Usage Examples
The following example sets the SNTP retry timeout to 10 seconds:
(config)#sntp retry-time 10
Advertising