Match address <listname – ADTRAN 1000R Series User Manual
Page 1242
Command Reference Guide
Crypto Map Manual Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
1242
match address <listname>
Use the match address command to assign an IP access list to a crypto map definition. The access list
designates the IP packets to be encrypted by this crypto map. See ip access-list extended <listname>
for more information on creating access lists.
Syntax Description
<listname>
Specifies the name of the access list you wish to assign to this crypto map.
Default Values
By default, no IP access lists are defined.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 Series units.
Command History
Release 4.1
Command was introduced.
Functional Notes
Crypto map entries do not directly contain the selectors used to determine which data to secure. Instead,
the crypto map entry refers to an access control list. An access control list (ACL) is assigned to the crypto
map using the match address command (see
) with the NetVanta 2000 and 3000
Series units. If no ACL is configured for a crypto map, then the entry is incomplete and will have no effect
on the system.
The entries of the ACL used in a crypto map should be created with respect to traffic sent by the ADTRAN
product. The source information must be the local ADTRAN product, and the destination must be the peer.
Only extended access lists can be used in crypto maps.