ADTRAN 1000R Series - Manual (Page 511)

Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 511
snmp-server source-interface <interface>
Use the snmp-server source-interface command to tell the AOS the interface type from which to expect
the SNMP traps to originate. All SNMP originated packets (including traps and get/set requests) will use
the designated interface’s IP address. Use the no form of this command to remove specified interfaces.
Syntax Description
<interface> Specifies the physical interface that should originate SNMP traps. Enter
snmp-server trap-source ? for a complete list of valid interfaces.
Default Values
By default, there are no trap-source interfaces defined.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 7.1 Command was introduced.
Usage Examples
The following example specifies that the Ethernet interface (ethernet 0/1) should be the source for all
SNMP traps and get/set requests:
(config)#snmp-server source-interface ethernet 0/1