ADTRAN 1000R Series - Manual (Page 631)

Command Reference Guide Ethernet Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 631
port-auth control-direction [both | in]
Use the port-auth control direction command to configure the direction in which traffic is blocked. This
command is only applicable when authentication is port-based. Use the no form of this command to return
to the default settings.
Syntax Description
both Blocks traffic in both directions when the port becomes unauthorized.
in Blocks only incoming traffic when the port becomes unauthorized.
Default Values
By default, traffic is blocked in both directions.
Applicable Platforms
This command applies to the NetVanta 1000 and 1000R Series units.
Command History
Release 10.1 Command was introduced.
Usage Examples
The following example causes traffic to be blocked in both directions when the port becomes unauthorized:
(config)#interface ethernet 0/1
(config-eth 0/1)#port-auth control-direction both