Loopback remote – ADTRAN 1000R Series User Manual
Page 693
Command Reference Guide
SHDSL Interface Configuration Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
693
loopback remote
Use the loopback remote command to send a loopback request to the remote unit. This command is
functional only in CO operating mode (see the section equipment-type [co | cpe]
). Use the no
form of this command to send a loopdown code to the remote unit to deactivate the loopback.
Syntax Description
No subcommands.
Default Values
No defaults necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 3.1
Command was introduced.
Usage Examples
The following example initiates a remote line loopback:
(config)#interface shdsl 1/1
(config-shdsl 1/1)#loopback remote