ADTRAN 1000R Series - Manual (Page 1171)

Command Reference Guide VLAN Database Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1171
show [changes <vlan id> | current | proposed]
Use the show command to display different aspects of the VLAN configuration.
Syntax Description
changes <vlan id> Displays the proposed changes to the VLAN configuration. You may specify a
VLAN ID to display only information for a specific VLAN. Valid VLAN interface ID
range is from 1 to 4094.
current Displays the current VLAN configuration. You may specify a VLAN ID to display
only information for a specific VLAN.
proposed Displays the proposed VLAN Database. The proposed version is not part of the
running configuration until it is applied (using the apply command or the exit
command). You may specify a VLAN ID to display only information for a specific
VLAN.
Default Values
No defaults necessary.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000 Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following example shows the proposed VLAN Database configuration which will take effect if an apply
or exit command is issued:
(config)#vlan database
(vlan)#show proposed