ADTRAN 1000R Series - Manual (Page 505)

Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 505
snmp-server enable traps <trap type> [snmp]
Use the snmp-server enable traps command to enable all Simple Network Management Protocol
(SNMP) traps available on your system or specified using the <trap type> option. Use multiple
snmp-server enable traps to enable multiple trap types. Use the no form of this command to disable traps
(or the specified traps).
Syntax Description
<trap type> Specifies the type of notification trap to enable. Leaving this option blank enables
ALL system traps.
snmp Optional. Enables a subset of traps specified in RFC1157.
The following traps are supported:
coldStart
warmStart
linkUp
linkDown
authenticationFailure
Default Values
By default, there are no enabled traps.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Usage Examples
The following example enables the SNMP traps:
(config)#snmp-server enable traps snmp