ADTRAN 1000R Series - Manual (Page 161)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 161
show auto-config
Use the show auto-config command to display auto-configuration status.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following is a sample output of the show auto-config command:
>enable
#show auto-config
Auto-Config is enabled, current status: Done.
TFTP Server is 10.20.20.1
Config filename is 1524STfile
Maximum retry count is 0 (repeat indefinitely), total retries is 0