ADTRAN 1000R Series - Manual (Page 545)

Command Reference Guide Line (SSH) Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 545
L INE (SSH) I NTERFACE C ONFIG C OMMAND S ET
To activate the Line Secure Shell (SSH) Interface Configuration mode, enter the line ssh command
specifying a SSH session(s) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#line ssh 0 4
(config-ssh0-4)#
You can select a single line by entering the line ssh command followed by the line number (0-4). For
example:
>enable
#configure terminal
(config)#line ssh 2
(config-ssh2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-class <listname> in on page 546
accounting commands [<level> l <name> l default] on page 547
authorization commands [<level> l <name> l default] on page 548
line-timeout <minutes> on page 549
login on page 550
login authentication <aaa login list> on page 551
login local-userlist on page 552