Atm interface config command set, Atm i – ADTRAN 1000R Series User Manual
Page 714
Advertising
![background image](/manuals/36101/714/background.png)
Command Reference Guide
ATM Interface Config Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
714
ATM I
NTERFACE
C
ONFIG
C
OMMAND
S
ET
To activate the ATM Interface Configuration mode, enter the interface atm command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface atm 1
(config-atm 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
All other commands for this command set are described in this section in alphabetical order.
Advertising