ADTRAN 1000R Series - Manual (Page 142)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 142
debug stack [SW_API | verbose]
Use the debug stack command to enable switch-stacking debug messages. Debug messages are displayed
(real time) on the terminal (or Telnet) screen. Use the no form of this command to disable the debug
messages.
Syntax Description
SW_API Enables messages specific to the stack ports.
verbose Enables messages specific to the stack protocol.
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 1000 and 1000R Series units.
Command History
Release 8.1 Command was introduced.
Usage Examples
The following example activates the possible debug stack messages:
>enable
#debug stack SW_API
#debug stack verbose