ADTRAN 1000R Series - Manual (Page 968)

Command Reference Guide HDLC Command Set
61200510L1-35E Copyright © 2005 ADTRAN 968
ip ospf network [broadcast | point-to-point]
Use the ip ospf network command to specify the type of network on this interface.
Syntax Description
broadcast Set the network type for broadcast.
point-to-point Set the network type for point-to-point.
Default Values
By default, Ethernet defaults to broadcast. PPP and Frame Relay default to point-to-point.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 9.1 Command was introduced.
Functional Notes
A point-to-point network will not elect designated routers.
Usage Examples
The following example designates a broadcast network type:
(config)#interface hdlc 1
(config-hdlc 1)#ip ospf network broadcast