ADTRAN 1000R Series - Manual (Page 847)

Command Reference Guide Frame Relay Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 847
frame-relay intf-type [dce | dte | nni]
Use the frame-relay intf-type command to define the Frame Relay signaling role needed for the endpoint.
Use the no form of this command to return to the default value.
Syntax Description
dce Specifies DCE or network-signaling role. Use this interface type when you need
the unit to emulate the frame switch.
dte Specifies DTE or user-signaling role. Use this interface type when connecting to a
Frame Relay switch (or piece of equipment emulating a frame switch).
nni Configures the interface to support both network and user signaling (DTE or DCE)
when necessary.
Default Values
By default, frame-relay intf-type is set to dte.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Usage Examples
The following example configures the Frame Relay endpoint for DCE signaling:
(config)#interface frame-relay 1
(config-fr 1)#frame-relay intf-type dce