ADTRAN 1000R Series - Manual (Page 532)

Command Reference Guide Line (Console) Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 532
L INE (C ONSOLE ) I NTERFACE C ONFIG C OMMAND S ET
To activate the Line (Console) Interface Configuration mode, enter the line console 0 command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#line console 0
(config-con 0)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
accounting commands [<level> l <name> l default] on page 533
authorization commands [<level> l <name> l default] on page 534
databits [7 | 8] on page 535
flowcontrol [none | software in] on page 536
line-timeout <minutes> on page 537
login on page 538
login authentication <aaa login list> on page 539
login local-userlist on page 540
parity [even | mark | none | odd | space] on page 541
password [md5] <password> on page 542
speed <rate> on page 543
stopbits [1 | 2] on page 544