ADTRAN 1000R Series - Manual (Page 323)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 323
write [dynvoice-config | erase | memory | network | terminal]
Use the write command to save the running configuration to the unit’s nonvolatile random access memory
(NVRAM) or a Trivial File Transfer Protocol (TFTP) server. Also use the write command to clear
NVRAM or to display the running configuration on the terminal screen. Entering the write command with
no other arguments copies your configuration changes to the unit’s NVRAM. Once the save is complete,
the changes are retained even if the unit is shut down or suffers a power outage.
Syntax Description
dynvoice-config Optional. Writes dynvoice configuration information to the unit’s NVRAM.
erase Optional. Erases the configuration files saved to the unit’s NVRAM.
memory Optional. Saves the current configuration to NVRAM. Refer to copy <source>
<destination> on page 87 for more information.
network Optional. Saves the current configuration to the network TFTP server. Refer to
copy tftp <destination> on page 91 for more information.
terminal Optional. Displays the current configuration on the terminal screen.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1 Command was introduced.
Usage Examples
The following example saves the current configuration to the unit’s NVRAM:
>enable
#write memory