ADTRAN 1000R Series - Manual (Page 1316)

Command Reference Guide Router (RIP) Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1316
R OUTER (RIP) C ONFIGURATION C OMMAND S ET
To activate the Router (RIP) Configuration mode, enter the router rip command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#router rip
(config-rip)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
auto-summary on page 1317
timeout-timer <seconds> on page 1324
network <address> <subnet mask> on page 1319
passive-interface <interface> on page 1320
redistribute connected [metric <value>] on page 1321
redistribute ospf [metric <value>] on page 1322
redistribute static [metric <value>] on page 1323
timeout-timer <seconds> on page 1324
update-timer <seconds> on page 1325
version [1 | 2] on page 1326