ADTRAN 1000R Series - Manual (Page 225)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 225
show ip mroute [<group-address> | <interface>] [summary | all]
Use the show ip mroute command to display IP multicasting routing table information.
Syntax Description
<group-address> Optional. Displays IP address of a multicast group.
<interface> Optional. Displays the parameters for a specific interface (in the format type
slot/port). For example: eth 0/1.
summary Optional. Displays a single-line summary for each entry in the IP multicast routing
table.
all Optional: Displays all multicast routes, including those not used to forward
multicast traffic.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 7.1 Command was introduced.
Release 9.1 Command was expanded to include HDLC and tunnel interfaces.
Release 11.1 The All option was added.
Usage Examples
The following is sample output from the show ip mroute command:
>enable
#show ip mroute
IP Multicast Routing Table
Flags: S - Sparse, C - Connected, P - Pruned, J - Join SPT, T - SPT-bit Set,
F - Register, R - RP-bit Set
Timers: Uptime/Expires
(*, 225.1.0.1), 01:16:21/00:02:45, RP 192.168.0.254, Flags: SC
Incoming interface: tunnel 2, RPF nbr 172.16.2.10
Outgoing interface list:
eth 0/1, Forward, 01:16:21/00:02:45