ADTRAN 1000R Series - Manual (Page 607)

Command Reference Guide E1 Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 607
snmp trap line-status
Use the snmp trap line-status command to control the Simple Network Management Protocol (SNMP)
variable dsx1LineStatusChangeTrapEnable (RFC2495) to enable (or disable) the interface to send SNMP
traps when there is an interface status change. Use the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, the dsx1LineStatusChangeTrapEnable OID is set to enabled for all interfaces except virtual
Frame Relay Interfaces.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 units.
Command History
Release 11.1 Command was introduced.
Functional Notes
The snmp trap line-status command is used to control the RFC2495 dsx1LineStatusChangeTrapEnable
OID (OID number 1.3.6.1.2.1.10.18.6.1.17.0).
Usage Examples
The following example disables the line-status trap on the T1 interface:
(config)#interface e1 1/1
(config-t1 1/1)#no snmp trap line-status