ADTRAN 1000R Series - Manual (Page 256)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 256
show mac address-table interface [<interface type> <interface id>
| vlan <vlan id>]
Use the show mac address-table interface command to display information regarding medium access
control (MAC) address table entries specific to a certain interface.
Syntax Description
<interface type> Shows information for a specific interface type. Type show mac address-table
interface ? for a list of valid interfaces.
<interface id> Shows address-table information related to a specific interface (e.g., eth 0/1).
vlan <vlan id> Shows address-table information related to a specific VLAN. Specifies a valid
VLAN interface ID (1 to 4094).
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000 Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following is an example of the show mac address-table interface eth 0/1 command displaying MAC
address-table entries specifically on Ethernet 0/1:
>enable
#show mac address-table interface ethernet 0/1
Mac Address Table
Vlan Mac Address Type Ports
2 00:90:2b:7d:30:00 DYNAMIC eth 0/1
2 00:a0:c8:05:00:ac DYNAMIC eth 0/1
2 00:a0:c8:05:00:ad DYNAMIC eth 0/1
2 00:a0:c8:05:00:c2 DYNAMIC eth 0/1
2 00:a0:c8:05:01:6e DYNAMIC eth 0/1
2 00:a0:c8:09:95:6b DYNAMIC eth 0/1
2 00:a0:c8:0a:2d:7c DYNAMIC eth 0/1
Total Mac Addresses for this criterion: 10