ADTRAN 1000R Series - Manual (Page 1263)

Command Reference Guide IKE Policy Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1263
client authentication host xauth-type [generic | otp | radius]
Use the client authentication host xauth-type command to allow the user to specify the Xauth
authentication type if a type other than generic is desired.
Syntax Description
generic Specifies generic authentication type.
otp Specifies OTP authentication type.
radius Specifies RADIUS authentication type.
Default Values
By default, this is set to generic.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1 Command was introduced.
Functional Notes
This command is used along with the client authentication host username. Refer to client configuration
pool <poolname> on page 1265 for more information. When acting as an Xauth host, this command allows
the user to specify the Xauth authentication type if a type other than generic is desired.
Usage Examples
The following example sets the Xauth type to radius:
(config-ike)#client authentication host xauth-type radius