ADTRAN 1000R Series - Manual (Page 859)

Command Reference Guide Frame Relay Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 859
hold-queue <queue size> out
Use the hold-queue out command to change the overall size of an interface's WAN output queue.
Syntax Description
<queue size> Specifies the total number of packets the output queue can contain before packets
are dropped. Range: 16 to 1000.
Default Values
The default queue size for WFQ is 400. The default queue size for PPP FIFO and Frame Relay round
robin is 200.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following example sets the overall output queue size to 700:
(config)#interface frame-relay 1
(config-fr 1)#hold-queue 700 out