Ip-range <start ip> <end ip – ADTRAN 1000R Series User Manual
Page 1252
Command Reference Guide
IKE Client Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
1252
ip-range <start ip> <end ip>
Use the ip-range command to specify the range of addresses from which the router draws when assigning
an IP address to a client.
Syntax Description
<start ip>
Specifies the first IP address in the range for this pool.
<end ip>
Specifies the last IP address in the range for this pool.
Default Values
By default, no IP address range is defined.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1
Command was introduced.
Usage Examples
The following example defines an IP address range for this configuration pool:
(config)#crypto ike client configuration pool ConfigPool1
(config-ike-client-pool)#ip-range 172.1.1.1 172.1.1.25