ADTRAN 1000R Series - Manual (Page 572)

Command Reference Guide BRI Interface Configuration Command set
61200510L1-35E Copyright © 2005 ADTRAN 572
bonding txnull-timer <seconds>
Use the bonding txnull-timer command to specify the value (in seconds) for the answering endpoint
negotiation timeout. Use the no form of this command to return to the default value.
Syntax Description
<seconds> Specifies the number of seconds the endpoint waits to detect the bonding
negotiation frame pattern from the originating endpoint (after answering a call)
before considering the bonding negotiation a failure.
Default Values
By default, the bonding txnull-timer value is 10 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1 Command was introduced.
Functional Notes
Specifies the length of time the answering endpoint attempts to detect the bonding negotiation pattern from
the originating endpoint before deciding the bonding call has failed. It may be necessary to shorten this
timer if the DTE equipment using the bonding module also has timer constraints for completing
non-bonding parameter negotiation.
Usage Examples
The following example defines a bonding txnull-timer value of 8 seconds:
(config)#interface bri 1/2
(config-bri 1/2)#bonding txnull-timer 8