ADTRAN 1000R Series - Manual (Page 735)

Command Reference Guide ATM Sub-Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 735
dial-backup number <digits> [analog | digital-56k | digital 64k]
<isdn min chan> <isdn max chan> <interface>
Use the dial-backup number command to configure the phone number and the call type the router will
dial upon network failure. Multiple entries can be made for a sub-interface to allow alternate sites to be
dialed. For more detailed information on ATM dial-backup functionality, refer to the Functional Notes and
Technology Review sections of the command dial-backup call-mode [answer | answer-always | originate |
originate-answer | originate-answer-always]
on page 729 .
Syntax Description
<digits> Specifies the phone numbers to call when the backup is initiated.
analog ppp Specifies number connects to an analog modem.
digital-56k Specifies number belongs to a digital 56 kbps per DS0 connection.
digital-64k Specifies number belongs to a digital 64 kbps per DS0 connection.
<isdn min chan> Specifies the minimum number of DS0s required for a digital 56 or 64 kbps
connection (Range: 1 to 24).
<isdn mas chan> Specifies the maximum number of DS0s desired for a digital 56 or 64 kbps
connection (Range: 1 to 24).
<interface> Specifies the ATM sub-interface (e.g., ATM 3.1) to use when originating or answering
using this number.
Default Values
By default, there are no configured dial-backup numbers.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1 Command was introduced.
Release 8.1 ATM sub-interface was added.
Usage Examples
The following example configures the AOS to dial 704-555-1212 (digital 64 kbps connection) to initiate
dial-backup operation on this endpoint:
(config)#interface atm 1.1
(config-atm 1.1)#dial-backup number 7045551212 digital-64k 1 1 atm 3.1