ADTRAN 1000R Series - Manual (Page 270)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 270
show processes [cpu | cpu realtime | history | queue | stack]
Use the show processes command to display process statistic information.
Syntax Description
cpu Displays informations about processes that are currently active.
cpu realtime Displays full-screen CPU output in real time. See the Functional Notes below for
more information.
history Displays the process switch history.
queue Displays process queue utilization.
stack Displays process stack usage.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1 Command was introduced.
Release 10.1 New option was introduced.
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
terminal length <text> on page
318 ).
Usage Examples
The following is a sample output from the show processes cpu command:
>enable
#show processes cpu
processes cpu
System load: 7.07% Min: 0.00% Max 85.89%
Context switch load: 0.21%