ADTRAN 1000R Series - Manual (Page 178)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 178
Keep-alive is set (10 sec.)
Admin MTU = 1500
Mode: Either, 1 dial entries, idleTime = 120, fastIdle = 20
Resource pool demand
No authentication configured
IP address 10.100.0.2 255.255.255.0
Connect Sequence: Successes = 0, Failures = 0
Seq DialString Technology Successes Busys NoAnswers NoAuths InUse
5 5552222 ISDN 0 0 0 0
Current values:
Local IP address 10.100.0.2, Peer IP address 10.100.0.1
Seconds until disconnect: 63
Queueing method: weighted fair
Output queue: 0/1/428/64/0 (size/highest/max total/threshold/drops)
Conversations 0/1/256 (active/max active/max total)
Available Bandwidth 48 kilobits/sec
Bandwidth=64 Kbps
Link through bri 1/3, Uptime 0:01:10
IN: Octets 588, Frames 19, Errors 0
OUT: Octets 498, Frames 18, Errors 0
Last callerID 2565552222, last called num 5552222
The following is example output from the show demand interface demand command:
>enable
#show demand interface demand 1
demand 1
Idle timer (120 secs), Fast idle timer (20 secs)
Dialer state is data link layer up
Dial reason: answered
Interface bound to resource bri 1/3
Time until disconnect 105 secs
Current call connected 00:00:27
Connected to 2565552222
Number of active calls = 1
Interesting Traffic = list junk
Connect Sequence: Successes = 0, Failures = 0
Seq DialString Technology Successes Busys NoAnswers NoAuths InUse
5 5552222 ISDN 0 0 0 0