Bandwidth <value – ADTRAN 1000R Series User Manual
Page 722
![background image](/manuals/36101/722/background.png)
Command Reference Guide
ATM Sub-Interface Config Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
722
bandwidth <value>
Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.
This value is used in cost calculations. Use the no form of this command to restore the default values.
Syntax Description
<value>
Specifies bandwidth in kbps.
Default Values
To view default values use the show interfaces command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 3.1
Command was introduced.
Release 8.1
ATM sub-interface was added.
Functional Notes
The bandwidth command is an informational value that is communicated to the higher-level protocols to
be used in cost calculations. This is a routing parameter only and does not affect the physical interface.
Usage Examples
The following example sets bandwidth of the ATM sub-interface to 10 Mbps:
(config)#interface atm 1.1
(config-atm 1.1)#bandwidth 10000