ADTRAN 1000R Series - Manual (Page 955)

Command Reference Guide HDLC Command Set
61200510L1-35E Copyright © 2005 ADTRAN 955
hold-queue <queue size> out
Use the hold-queue command to change the overall size of an interface's WAN output queue.
Syntax Description
<queue size> The total number of packets the output queue can contain before packets are
dropped. Range: 16 to 1000.
Default Values
The default queue size for WFQ is 400. The default queue size for PPP FIFO and Frame Relay
round-robin is 200.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 9.1 Command was introduced.
Usage Examples
The following example sets the overall output queue size to 700:
(config)#interface hdlc 1
(config-hdlc 1)#hold-queue 700