ADTRAN 1000R Series - Manual (Page 159)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 159
show arp [realtime]
Use the show arp command to display the Address Resolution Protocol (ARP) table.
Syntax Description
realtime Displays full-screen output in real time. See the Functional Notes below for more
information.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Release 10.1 The real time display option was introduced.
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
terminal length <text> on page
318 ).
Usage Examples
The following is a sample output of the show arp command:
>enable
#show arp
ADDRESS TTL (min) MAC ADDRESS LAST UPDATED (min) INTERFACE
192.168.30.36
192.168.30.253
224.0.0.9
13
17
71578541
00:E0:7D:88:1A:B9
02:60:8C:DD:0A:CE
01:00:5E:00:00:09
4260
4264
0
eth 0/1
eth 0/1
eth 0/2