ADTRAN 1000R Series - Manual (Page 1143)

Command Reference Guide Tunnel Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1143
ip ospf
Use the ip ospf command to customize OSPF settings (if needed).
Syntax Description
authentication-key Specifies a simple-text authentication password to be used
by other routers using <password> the OSPF simple
password authentication.
cost <value> Specifies the OSPF cost of sending a packet on the interface.
This value overrides any computed cost value.
Range: 1 to 65,535.
dead-interval <seconds> Sets the maximum interval allowed between hello packets. If
the maximum is exceeded, neighboring devices will
determine that the device is down. Range: 0 to 32,767.
hello-interval <seconds> Specifies the interval between hello packets sent on the
interface. Range: 0 to 32,767.
message-digest-key <keyid> md5 <key> Configures OSPF Message Digest 5 (MD5) authentication
(16-byte max) keys.
priority <value> Set the OSPF priority. The value set in this field helps
determine the designated router for this network.
Range: 0 to 255.
retransmit-interval <seconds> Specifies the time between link-state advertisements (LSAs).
Range: 0 to 32,767.
transmit-delay <seconds> Sets the estimated time required to send an LSA on the
interface. Range: 0 to 32,767.
Default Values
retransmit-interval <seconds> 5 seconds
transmit-delay <seconds> 1 second
hello-interval <seconds> 10 seconds: Ethernet, point-to-point, Frame Relay, Tunnel,
and PPP
dead-interval <seconds> 40 seconds
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1 Command was introduced.
Release 9.1 Command was expanded to include tunnel interfaces.