ADTRAN 1000R Series - Manual (Page 1175)

Command Reference Guide VLAN Database Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1175
vlan <vlan id> state [active | suspend]
Use the vlan state command to change the state of the VLAN. Use the no form of this command to return
to the default setting.
Syntax Description
<vlan id> Specifies a valid VLAN interface ID (1 to 4094).
active Changes the VLAN state to active.
suspend Changes the VLAN state to suspended.
Default Values
The default setting is active (once the VLAN has been created).
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000 Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following example sets the VLAN state to suspended:
(config)#vlan database
(vlan)#vlan 2 state suspend