ADTRAN 1000R Series - Manual (Page 32)

Command Reference Guide Common Commands
61200510L1-35E Copyright © 2005 ADTRAN 32
do
Use the do command to execute any AOS command, regardless of the active configuration mode. It
provides a way to execute commands in other modes without taking the time to exit the current mode and
enter the desired one.
Syntax Description
No subcommands.
Default Values
No defaults required for this command.
Applicable Command Modes
Applies to all mode command sets.
Applicable Platforms
Applies to all AOS products.
Command History
Release 2.1 Command was introduced.
Functional Notes
Use the do command to view configurations or interface states after configuration changes are made
without exiting to the Enable mode.
Usage Examples
The following example shows the do command used to view the Frame Relay interface configuration while
currently in the T1 Interface Configuration mode:
(config)#interface t1 1/1
(config-t1 1/1)#do show interfaces fr 7
fr 7 is ACTIVE
Signaling type is ANSI signaling role is USER
Polling interval is 10 seconds full inquiry interval is 6 polling intervals
Output queue: 0/0 (highest/drops)
0 packets input 0 bytes
0 pkts discarded 0 error pkts 0 unknown protocol pkts
0 packets output 0 bytes
0 tx pkts discarded 0 tx error pkts