ADTRAN 1000R Series - Manual (Page 36)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 36
E NABLE M ODE C OMMAND S ET
To activate the Enable mode, enter the enable command at the Basic mode prompt. (If an enable password
has been configured, a password prompt will display.) For example:
>enable
Password: XXXXXXX
#
The following command is common to multiple command sets and is covered in a centralized section of
this guide. For more information, refer to the section listed below:
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
clear commands begin on page 38
clock auto-correct-dst on page 80
clock no-auto-correct-dst on page 81
clock set <time> <day> <month> <year> on page 82
clock timezone <text> on page 83
configure [memory | network | overwrite-network | terminal] on page 86
copy <source> <destination> on page 87
copy console <filename> on page 88
copy flash <destination> on page 89
copy <filename> interface <interface> <slot/port> on page 90
copy tftp <destination> on page 91
copy xmodem <destination> on page 92
debug commands begin on page 93
dir on page 146
dir [<input> | flash | flash <input>] on page 147
disable on page 148
enable on page 149
erase [<filename> | startup-config] on page 150
events on page 151
exception report generate on page 152
logout on page 153
ping <address> on page 154
ping stack-member on page 156
reload [cancel | in <delay>] on page 157