ADTRAN 1000R Series - Manual (Page 1103)

Command Reference Guide PPP Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1103
pppoe ac-name <name>
Use the pppoe ac-name command to identify the Access Concentrator (AC) with which the AOS expects
to establish a PPPoE session. Use the no form of this command to return to the default setting.
Syntax Description
<name> Specifies an AC by text string (up to 255 characters) corresponding to the
AC-Name Tag under RFC2516. If this field is not specified, any access
concentrator is acceptable. The AC value may be a combination of trademark,
model, and serial ID information (or simply the MAC address of the unit).
Default Values
By default, no AC is specified.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following example identifies the AC with which the AOS expects to establish a PPPoE session:
(config)#interface ppp 1
(config-ppp 1)#pppoe acc-name Access_Concentrator_Name