ADTRAN 1000R Series - Manual (Page 746)

Command Reference Guide ATM Sub-Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 746
hold-queue <queue size> out
Use the hold-queue out command to change the overall size of an interface's WAN output queue.
Syntax Description
<queue size> Specifies the total number of packets the output queue can contain before packets
are dropped. Range: 16 to 1000.
Default Values
The default queue size for WFQ is 400. The default queue size for PPP FIFO and Frame Relay
round-robin is 200.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 5.1 Command was introduced.
Release 8.1 ATM sub-interface was added.
Usage Examples
The following example sets the overall output queue size to 700:
(config)#interface atm 1.1
(config-atm 1.1)#hold-queue 700 out