ADTRAN 1000R Series - Manual (Page 660)

Command Reference Guide Ethernet Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 660
switchport trunk fixed vlan [add l all l except l none l remove] <vlan id>
Use the switchport trunk fixed vlan command to change the configured list of VLANs that remain fixed
in use only when GVRP is enabled on the interface. Of these VLANs, VLANs statically created will be
available for use on the interface.
Syntax Description
add Adds VLANs to the VLAN GVRP trunking fixed list.
all Adds all VLANs to the VLAN GVRP trunking fixed list.
except Adds all VLAN IDs to the VLAN trunking fixed list except those in the command
line VLAN ID list.
none Removes all VLANs from the VLAN GVRP trunking fixed list.
remove Removes VLAN from the VLAN trunking fixed list.
<vlan id> Specifies a valid VLAN interface ID (1 to 4094).
Default Values
By default, no VLANs are in the VLAN GVRP trunking fixed list (switchport trunk fixed vlan none).
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 8.1 Command was introduced.
Functional Notes
This command has no effect on VLAN membership configuration unless GVRP is enabled on the interface.