ADTRAN 1000R Series - Manual (Page 1214)

Command Reference Guide VLAN Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1214
traffic-shape rate <rate> [<burst>]
Use the traffic-shape rate command to specify and enforce an output bandwidth for the VLAN interface.
Syntax Description
<rate> Specifies the rate (in bits per second) at which the interface should be shaped.
<burst> Optional. Specifies the allowed burst in bytes. By default, the burst is specified as the
rate divided by 5 and represents the number of bytes that would flow within 200 ms.
Default Values
By default, traffic-shape rate is disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, and 2000 Series units.
Command History
Release 10.1 Command was introduced.
Functional Notes
Traffic shaping can be used to limit the VLAN interface to a particular rate or to specify use of QoS.
Usage Examples
The following example sets the outbound rate of vlan 1 to 128 kbps and applies a QoS policy that all RTP
traffic is given priority over all other traffic:
(config)#qos map voip 1
(config-qos-map)#match ip rtp 10000 10500 all
(config-qos-map)#priority unlimited
(config-qos-map)#interface vlan 1
(config-interface-vlan 1)#traffic-shape rate 128000
(config-interface-vlan 1)#qos-policy out voip