ADTRAN 1000R Series - Manual (Page 886)

Command Reference Guide Frame Relay Sub-Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 886
dial-backup restore-delay <seconds>
Use the dial-backup restore-delay command to configure the amount of time the router will wait after the
network is restored before disconnecting the backup link and reverting to the primary. This setting is used
to prevent disconnecting the backup link if the primary link is “bouncing” in and out of alarm. For more
detailed information on Frame Relay dial-backup functionality, refer to the Functional Notes and
Technology Review sections of the command dial-backup call-mode [answer | answer-always | originate |
originate-answer | originate-answer-always]
on page 876 .
Syntax Description
<seconds> Specifies the number of seconds the AOS will wait (after a primary link is restored)
before disconnecting dial-backup operation. Range: 10 to 86,400.
Default Values
By default, dial-backup restore-delay is set to 10 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 1.1 Command was introduced.
Usage Examples
The following example configures the AOS to wait 30 seconds before disconnecting dial-backup operation
and restoring the primary connection for this endpoint:
(config)#interface frame-relay 1.16
(config-fr 1.16)#dial-backup restore-delay 30