ADTRAN 1000R Series - Manual (Page 288)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 288
show spanning-tree <bridgegroup#>
Use the show spanning-tree command to display the status of the spanning-tree protocol.
Syntax Description
<bridgegroup#> Optional. Displays spanning-tree for a specific bridge group.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following is an example output using the show spanning-tree command:
>enable
#show spanning-tree
Spanning Tree enabled protocol ieee
Root ID Priority 32768
Address 00:a0:c8:00:88:41
We are the root of the spanning tree
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 32768
Address 00:a0:c8:00:88:41
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 300
Interface
-------------------
Role
-------------------
Sts
-------------------
Cost
-----------
Prio.Nbr
-------------
Type
---------------
eth 0/2 Desg FWD 19 128.2 P2p
eth 0/3 Desg FWD 19 128.3 P2p
eth 0/4 Desg FWD 19 128.4 P2p
giga-eth 0/1 Desg FWD 4 128.25 P2p
giga-eth 0/2 Desg FWD 4 128.26 P2p