ADTRAN 1000R Series - Manual (Page 172)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 172
show crypto ike
Use the show crypto ike command to display information regarding the IKE configuration.
Variations of this command include the following:
show crypto ike client configuration pool
show crypto ike client configuration pool <poolname>
show crypto ike policy
show crypto ike policy <policy priority>
show crypto ike remote-id <remote-id>
show crypto ike sa
Syntax Description
client configuration pool Displays the list of all configured IKE client configuration pools.
<poolname> Displays detailed information regarding the specified IKE client configuration
pool.
policy Displays information on all IKE policies. Indicates if client configuration is
enabled for the IKE policies and displays the pool names.
<policy priority> Displays detailed information on the specified IKE policy. This number is
assigned using the crypto ike policy command. Refer to
crypto ike on page
367 for more information.
remote-id <remote-id> Displays information on all IKE information regarding the remote-id. The
remote-id value is specified using the crypto ike remote-id command (refer
to
crypto ike remote-id on page 371 ).
sa Displays the configuration of active IKE security associations.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1 Command was introduced.