Route map command set, Route map command set 3 – ADTRAN 1000R Series User Manual
Page 1353
Advertising
Command Reference Guide
Route Map Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
1353
R
OUTE
M
AP
C
OMMAND
S
ET
To activate the Route Map Interface Configuration mode, enter the route-map command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#route-map MyMap permit 100
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
All other commands for this command set are described in this section in alphabetical order.
match community <name> [exact-match]
match ip address <access list name>
match ip address prefix-list <prefix-list name>
Advertising