Snmp trap – ADTRAN 1000R Series User Manual

Page 1011

Advertising
background image

Command Reference Guide

Loopback Interface Configuration Command Set

61200510L1-35E

Copyright © 2005 ADTRAN

1011

snmp trap

Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)
traps on the interface.

Syntax Description

No subcommands.

Default Values

By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps
enabled.

Applicable Platforms

This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.

Command History

Release 1.1

Command was introduced.

Release 3.1

Command was extended to the SHDSL interface.

Release 5.1

Command was expanded to include Ethernet sub-interfaces and Gigabit Ethernet
interfaces.

Usage Examples

The following example enables SNMP capability on the Ethernet interface:

(config)#interface eth 0/1

(config-eth 0/1)#snmp trap

Advertising