ADTRAN 1000R Series - Manual (Page 1227)

Command Reference Guide Certificate Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1227
certificate <serial-number>
Use the certificate command to restore a certificate. Use the no form of this command to remove a specific
certificate from the certificate chain.
Syntax Description
<serial-number> Specifies the certificate’s serial number (up to 51 characters). This value can be
found for existing certificates by using the show run command.
Default Values
No defaults necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1 Command was introduced.
Functional Notes
The user typically does not enter this command. It is primarily used to restore certificates from the startup
configuration when the product is powered up.
Usage Examples
The following example removes the certificate with the serial number
73f0bfe5ed8391a54d1214390a36cee7:
(config)#crypto ca certificate chain MyProfile
(config-cert-chain)#no certificate 73f0bfe5ed8391a54d1214390a36cee7