Copy xmodem <destination – ADTRAN 1000R Series User Manual

Page 92

Advertising
background image

Command Reference Guide

Enable Mode Command Set

61200510L1-35E

Copyright © 2005 ADTRAN

92

copy xmodem <destination>

Use the copy xmodem command to copy a file (using the XMODEM protocol) to a specified destination.
XMODEM capability is provided in terminal emulation software such as HyperTerminal™.

Syntax Description

<destination>

Specifies the destination of the copied file.

Valid destinations include: flash (FLASH memory), startup-config (the
configuration file stored in NVRAM), or running-config (the current running
configuration file).

After entering copy xmodem and specifying a destination, the AOS prompts for
the following information:

Destination filename:

Specifies the filename to use when storing the copied file to FLASH memory.
(Valid only for the copy flash command.)

Default Values

No default value necessary for this command.

Applicable Platforms

This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.

Command History

Release 1.1

Command was introduced.

Usage Examples

The following example copies a .biz file to flash memory and labels it newfile.biz:

>enable

#copy xmodem flash

Destination filename newfile.biz

Begin the Xmodem transfer now...

Press CTRL+X twice to cancel

CCCCCC

The AOS is now ready to accept the file on the CONSOLE port (using the XMODEM protocol). The next
step in the process may differ depending on the type of terminal emulation software you are using. For
HyperTerminal, you will now select Transfer > Send File and browse to the file you wish to copy. Once the
transfer is complete, information similar to the following is displayed:

Received 231424 bytes.

Transfer complete.

Advertising