ADTRAN 1000R Series - Manual (Page 267)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 267
show power inline <slot/port> [realtime]
Use the show power inline command to display power information (in watts) for devices connected to
power over Ethernet (PoE) interfaces. The command also displays the PoE interfaces that can be powered,
whether the interfaces are powered or not, and the IEEE class for the device(s) connected to the PoE
interfaces.
Syntax Description
<slot/port> Optional. Specifies the slot/port of a PoE interface. If specified, the command only
displays information related to that interface.
realtime Displays full-screen output in real time. See the Functional Notes below for more
information.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000 and 1000R series units.
Command History
Release 9.1 Command was introduced.
Release 11.1 The real time display option was added.
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
terminal length <text> on page
318 ).
Usage Examples
The following example displays power information for all PoE interfaces:
>enable
#show power inline
Interface Admin Oper Power Class
(watts)
eth 0/1 auto off n/a n/a