ADTRAN 1000R Series User Manual

Page 779

Advertising
background image

Command Reference Guide

ATM Sub-Interface Config Command Set

61200510L1-35E

Copyright © 2005 ADTRAN

779

spanning-tree link-type [auto | point-to-point | shared]

Use the spanning-tree link-type command to configure the spanning-tree protocol link type for an
interface. To return to the default value, use the no form of this command.

Syntax Description

auto

Determines link type by the port’s duplex settings.

point-to-point

Manually sets link type to point-to-point, regardless of duplex settings.

shared

Manually sets link type to shared, regardless of duplex settings.

Default Values

By default, a port is set to auto.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.

Command History

Release 5.1

Command was introduced.

Release 8.1

ATM sub-interface was added.

Functional Notes

This command overrides the default link-type setting determined by the duplex of the individual port. By
default a port configured for half-duplex is set to shared link type, and a port configured for full-duplex is
set to point-to-point link type. Setting the link type manually overrides the default and forces the port to
use the specified link type. Using the link-type auto command, restores the convention of determining link
type based on duplex settings.

Usage Examples

The following example forces the link-type to point-to-point, even if the port is configured to be half-duplex:

(config)#bridge 1 protocol ieee

(config)#interface atm 1.1

(config-atm 1.1)#spanning-tree link-type point-to-point

Technology Review

Rapid transitions are possible in rapid spanning-tree protocol (RSTP) by taking advantage of point-to-point
links (a port is connected to exactly one other bridge) and edge-port connections (a port is not connected
to any additional bridges). Setting the link type to auto allows the spanning tree to automatically configure
the link type based on the duplex of the link. Setting the link type to point-to-point allows a half-duplex link
to act as if it were a point-to-point link.

Advertising