ADTRAN 1000R Series - Manual (Page 1163)

Command Reference Guide VLAN Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1163
VLAN C ONFIGURATION C OMMAND S ET
To activate the VLAN Configuration mode, enter the vlan command at the Global Configuration mode
prompt. For example:
>enable
#configure terminal
(config)#vlan 1
(config-vlan 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
media [ethernet] on page 1164
name <vlan name> on page 1165
state [active | suspend] on page 1166