ADTRAN 1000R Series - Manual (Page 1180)

Command Reference Guide VLAN Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1180
arp arpa
Use the arp arpa command to enable address resolution protocol (ARP) on the VLAN interface.
Syntax Description
arpa Sets the standard address resolution protocol for this interface.
Default Values
The default for this command is arpa.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000 Series units.
Command History
Release 5.1 Command was introduced.
Release 6.1 Command was extended to include NetVanta 2000 Series units.
Usage Examples
The following example enables standard ARP for the VLAN interface:
(config)#interface vlan 1
(config-interface-vlan 1)#arp arpa