ADTRAN 1000R Series - Manual (Page 932)

Command Reference Guide HDLC Command Set
61200510L1-35E Copyright © 2005 ADTRAN 932
bandwidth <value>
Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.
This value is used in cost calculations. Use the no form of this command to restore the default values.
Syntax Description
<value> Enter bandwidth in kbps.
Default Values
To view default values use the show interfaces command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 9.1 Command was introduced.
Functional Notes
The bandwidth command is an informational value that is communicated to the higher-level protocols to
be used in cost calculations. This is a routing parameter only and does not affect the physical interface.
Usage Examples
The following example sets bandwidth of the HDLC interface to 10 Mbps:
(config)#interface hdlc 1
(config-hdlc 1)#bandwidth 10000